The Full Command

Command Summary

Sets the screen mode to FULL.

Command Syntax


Menu Location

In the BASIC editor,

  1. Press [MODE]
  2. Press [DOWN] seven times
  3. Press [ENTER] to insert Full

Calculator Compatibility


Token Size

1 byte

The Full command cancels the effects of either Horiz or G-T.

Full is usually used either at the beginning and/or ending of a program. It is used at the beginning to ensure that the screen mode is Full, the standard setting. It is used at the end if the screen mode was changed in the middle of the program (as clean up).


Related Commands


Unless otherwise stated, the content of this page is licensed under Creative Commons Attribution-NonCommercial-ShareAlike 3.0 License