configuration stuff: ti-84+se v 2.43
TI connect editor 6.1 (v19)
mac desktop v 10.4.11
when in the editor i goto the catalog and find the negative symbol and the minus symbol. and put them side by side in the editor according to TI-cares the minus symbol is longer and lower than the negative symbol. you should note the negative symbol comes just after the + symbol in the catalog at the very end of the list. The one line statement I am trying to run is TEXT(negative symbol 1, start x pixel location,start y pixel location,"text to print") a specific example :
TEXT(-1,0,0,"HI THERE") will place large text in this case HI THERE (done by negative symbol and the charter 1 in the upper left corner of the graphing screen. it works just find when done in the calculator. based on the ti view of the two symbols i am sure that i am using the correct symbol in the data editor. when i send and execute the text message i get err:syntax when i go to goto the cursor sits on the minus symbol i change to the negative symbol and the program runs. running mac 10.4.11